Mio Technology Water Dispenser STANDARD Manual de usuario

AquachlorSalt Water ChlorinatorOwners ManualModelStandard andSelf Clean C Series IIManufactured in Australia ByMonarch Pool Systemswww.monarchpoolsys

10The Aquachlor unit has a built in warning system to minimise damage resulting frominsufficient salt levels, however, the ultimate responsibility

11AquachlorModel C(Standard)AquachlorModel SC(Self Clean)Productionmaximumgrams/hour(100%)Production*grams/hour(65%equivalent)Chlorineproducedover 8ho

12IMPORTANT: ALWAYS INSIST ON GENUINE AQUACHLOR REPLACEMENT PARTS. If it isnecessary to replace the Electrolytic Cell, beware of “lo

2AquachlorSalt ChlorinatorThankyou for purchasing a Quality Aquachlor Pool and Spa Product. Please read allinformation in this Manual carefully befor

3INSTALLATION INSTRUCTIONS FOR AQUACHLOR C and SCINSTALLING THE POWER SUPPLY:Select a convenient well-ventilated location within one metre of f

4PRE - START UP PROCEDURE:Before operating your Aquachlor Chlorinator please ensure the following items havebeen added to your pool:• SALT - Load sa

5BAR METERWARNINGLEDREASON/ACTIONOffGreen1. Start – up delay functioning.2. System Control set belowmax. Cell is turned off. (ReferSystem Control p

6If the Cell is OFF and you wish to check its operation, simply turn the System Control toMAX and the Cell will turn ON. Once checked, adjust the Syst

7Terminal Block the coloured wires from your pool light are connected. The LightTransformer is for use with 12volt pool lights, maximum p

8Aquachlor  C StandardAquachlor SC Self CleanC StandardSystems ModelC Replacement CellModel to orderSC Self CleanSystems ModelSC ReplacementCell

9Stabiliser should be added at the rate of 500 grams for every 10,000 litres of water. Toadd, place the required amount in a stocking and tie a brick