Mio MIOMAP C220 Manual de usuario

1.2 Performing the Initial Start Up 1. Make sure that power is supplied to your device. (See the next section.) 2. For the initial start up, press

5. The Home screen appears. You can now use your device. 5

1.3 Using Your Device in a Vehicle Using the Device Holder CAUTION: z Select an appropriate location for the device holder. Never place the holder w

CAUTION: For optimal performance of the lithium battery, take note of the following: z Do not charge the battery where the temperature is high (e.g.

z Drag Hold your fingertip on the screen and drag up/down/left/right or across the screen. z Tap and hold Tap and hold your fingertip until an actio

2 Troubleshooting and Maintenance nding; or appears to be “frozen” or “locked up.” he “Power Off Selection” screen appears aTroubleshooting and Main

2.2 Troubleshooting er a problem you cannot solve, contact an authorized service center for NOTE: If you encountassistance. Power Problems Power doe

z Make sure that thcomputer and one cable is securely plugged into the USB port on your the device. Connect the USB cable directly to your nnect you

z The screen surface can easily be scratched. Avoid touching it with sharp objects. Non-adhesive generic screen protectors designed specifically foon

3 Regulatory Information NOTE: Marking labels located on the exterior of your device indicate the regulations that your model complies with. Please

R03 Trademarks All brand and product names are trademarks or registered trademarks of their respective companies. Note The inform

z Increase the separation between the equipment and receiver. z Connect the equipment into an outlet on a circuit different from that to which the r

EN6100-3-2: Limits for harmonic current emissions EN6100-3-3: Limitation of voltage fluctuation and flicker in low-voltage supply system EN60950 / IEC

About the Battery z Use a specified charger approved by the manufacturer. CAUTION: This unit contains a non-replaceable internal Lithium Ion battery.

Table of Contents 1 Getting Started...1 1.1 Understanding Hardware Co

About the Charger... 15 About the Battery ...

Warnings and Notices z For your safety, do not operate the controls of the product while driving. z Use this product with caution. The product is a

z A device holder is needed when using the device in a car. Be sure to place the device in an appropriate place, so as not to obstruct the driver’s v

1 Getting Started 1.1 Understanding Hardware Components NOTE: Depending upon the specific model purchased, the color of your device may not exactly

Back Components Ref Component Description n Speaker Sends out music, sounds and voice. Right-side Components 2

Ref Component Description n SD/MMC Slot Accepts an SD (Secure Digital) or MMC (MultiMedia Card) card for accessing data such as map data. o Headphon